OP-TEE uses both 32bit as well as 64bit toolchains and it is even possible to mix them in some configurations. In theory you should be able to compile OP-TEE with the Arm toolchains that are coming with your Linux distribution. But instead of using those directly, we instead download the toolchains directly from Arm.


We propose two ways to download the toolchains, both will put the toolchains under the same path(s).

Direct download

Go the Arm GCC download page and download the “AArch32 target with soft float (arm-linux-gnueabi)” for 32bit builds and the “AArch64 GNU/Linux target (aarch64-linux-gnu)” for 64bit builds. When the downloads have finished, you will untar them to a location that you later on will export to your $PATH. Here is an example

$ mkdir -p $HOME/toolchains
$ cd $HOME/toolchains

# Download 32bit toolchain
$ wget
$ mkdir aarch32
$ tar xf gcc-arm-8.2-2019.01-x86_64-arm-linux-gnueabi.tar.xz -C aarch32 --strip-components=1

# Download 64bit toolchain
$ wget
$ mkdir aarch64
$ tar xf gcc-arm-8.2-2019.01-x86_64-aarch64-linux-gnu.tar.xz -C aarch64 --strip-components=1

Using build.git

As an alternative, you can let build.git download them for you, but this of course involves getting a git that you might not otherwise use.

$ cd $HOME
$ git clone
$ cd build
$ make -f -j2

Export PATH

If you have downloaded the toolchains as described above, you should have them at $HOME/toolchains/{aarch32/aarch64}, so now we just need to export the paths and then you are ready to starting compiling OP-TEE components.

$ export PATH=$PATH:$HOME/toolchains/aarch32/bin:$HOME/toolchains/aarch64/bin