HiKey 620

The instructions here will tell how to run OP-TEE on HiKey 620.

Multiple sources for HiKey and OP-TEE instructions?

First you must understand that the HiKey project as such is led by the 96Boards project. So, if you aren’t interested in running OP-TEE on the device, then you should stop reading here and instead have a look at the official HiKey documentation.

For OP-TEE using HiKey you will still find information in more than one place. There are a couple of reasons for that.

  • 96Boards: The official 96Boards project used to host some OP-TEE instructions and they include OP-TEE in their official releases.
  • Google: has an AOSP HiKey branch, where OP-TEE is supported to some extent.
  • Linaro-SWG: The OP-TEE team has done some work related to AOSP (see the AOSP page) and there HiKey has been one of the devices in use.

If you have questions regarding the configurations above, please reach out to the people on the right forum (96Boards, Google and Linaro-SWG).

This particular guide is maintained by the OP-TEE core team and this is what we use when we are doing are stable releases for our OP-TEE developer builds. I.e, for OP-TEE this should be considered as a well maintained guide with a fully working setup.

Supported HiKey boards

There are four different versions of the HiKey board.

Name Manufacturer Memory Flash Comment
HiKey CircuitCo 1GB 4GB Green solder mask
HiKey LeMaker 1GB 8GB Black solder mask
HiKey LeMaker 2GB 8GB Black solder mask

All of them works, but where differences apply we have default configurations that works for the LeMaker 8GB eMMC versions.

UART adapter board

Everything is configured to use the 96Boards UART Adapter Board. The UART is by default configured to UART3. If you don’t have any UART adapter board and instead would like to use UART0, then you need to change that before building. See CFG_NW_CONSOLE_UART and CFG_NW_CONSOLE_UART in hikey.mk.

Build instructions

Just follow the “Get and build the solution” as described in build. The make flash step will tell you how you should set the jumpers on the board.

Recovery

If you manage to corrupt the device, so that fastboot doesn’t load automatically on boot, then you will need to run the recovery procedure. Basically what you will need to do is use another make target and change some jumpers. All that is described when you run the target:

$ make recovery